Cardinal Detecto PZ3000 Series Manuel du propriétaire télécharger pdf (Page 7)

8528-M372-O1 Rev E  PZ3000 Series

POWER CONNECTION, CONT.

7. Slide one side of the battery door so that it clears the edge of the indicator enclosure and

then remove the battery door.

8. Place the battery door on a table or bench with the battery holder and battery strap up.

9. Referring to Figure No. 3, remove the 2 Philips screws securing the battery strap to the

battery door and remove the strap.

10. To install or replace the batteries, first remove the battery holder cover by pushing in on

the tab and lifting it up. Refer to Figure No. 4.

11. If replacing the batteries, remove all 6 batteries from the battery holder. If installing new

batteries, proceed to step 12.

NOTE: To insure optimum performance of your PZ3000 when powered by the

internal battery, replace all 6 batteries with new “AA” size, NiMH batteries

(2300mAh minimum). DO NOT mix new and used batteries.

12. Install the 6 new “AA” size batteries in the battery holder, noting the polarity markings

located in the battery holder. Refer to Figure No. 5.

13. After placing all 6 batteries in the holder, replace the battery cover and battery strap.

Secure the battery strap with the 2 Philips screws removed earlier.

14. Replace the battery door on the indicator and then re-connect the connector on the end of

the battery holder.

ure No. 3

Remove Philips Screws

Battery

Connector

Battery Strap

Push in and

lift here

ure No. 4

Battery

Cover

1 2 3 4 5 6 7 8 9 10 11 12 ... 27 28

Pas de commentaire

Cardinal Detecto PZ3000 Series Manuel du propriétaire Page 7